Step one: Wall cleaning

Fill in all cracks or holes. Polished wall with fine sandpaper and use a sponge to clean dust dirt or grease on the wall.

Step two: Create a plumb line

Use a tape measure or sprint level to mark the vertical line for the first part.

Step three: Use a scraper

Peel off the backing paper, Use a scraper to install the first mural from top to bottom by vertical line and smooth out any air bubbles from the middle to both sides.


Note: reserve 1 inch mural on the left when installing the first panel. After you finish it cut off the excess parts.

Step four: Install the next panel

Match out the subsequent parts by sliding into place.

Step five: No overlapping

Match the edge of the previous part directly according to the pattern. Until the perfect seamless stitching.
Continue to install each panel as you go.



Note: installing near the power switch. you can cut the diagonal of the power switch similar to "X", and cut off the excess part.